





Flat roof materials for a complete timber roof build
This project collection brings together the main materials used through a typical timber flat roof build, from the structural timbers and roof fall through to the deck, insulation and EPDM roof covering. The exact timber sizes, spacing, insulation build-up and detailing should follow the requirements of your individual project.
1. Start with the structural roof timbers
The roof structure comes first. Choose the treated structural timber section and length required for the job, based on the roof design and specification. Once the supporting structure is set out, the remaining roof build can be planned around it.
2. Create the roof fall with timber firrings
Flat roofs still need a fall to move water towards the drainage point. Our timber firring strips are available in 3" to 0" and 4" to 0" pairs, with angle or tilt fillet also available for edge and detail work. Select the firring size and layout to suit the required roof build.
3. Choose the flat roof deck
We stock OSB3 sheet material and 18mm OSB3 tongue and groove board as roof-deck options. The correct board, thickness and support arrangement depends on the roof design and specification, so check the requirements of the individual job before ordering.
4. Add PIR insulation where required
PIR insulation boards are available for insulated flat roof build-ups. The insulation thickness and position within the roof should match the intended construction and project requirements rather than being selected as a one-size-fits-all option.
If you are deciding whether the insulation belongs above the deck or between the joists, read our warm roof vs cold roof guide.
5. Finish with EPDM rubber roofing
Our Techno EPDM system includes 1.2mm rubber roofing membrane cut to size, along with water-based adhesive, contact adhesive, primer and detailing tapes. Choose the membrane size and the compatible system products required for the roof area and details.
6. Complete the roof edges, corners and gutter details
Finish the EPDM roof with the appropriate edge trims, gutter trim system, internal and external corners and detailing products. Planning these parts at the same time as the membrane helps make sure the full roof covering system is included in the order.
Flat roof project FAQs
What materials do I need to build a flat roof?
A typical timber flat roof project can include structural roof timbers, firrings to create the fall, a roof deck, insulation where required, the roof covering and the trims and detailing products needed to finish it. The exact build-up varies by project.
Can I buy the EPDM membrane cut to size?
Yes. The Techno TRC 045 EPDM membrane in this collection is sold cut to size, allowing you to choose the membrane dimensions needed for the roof.
Which OSB should I use for a flat roof?
This collection includes OSB3 sheet material and 18mm OSB3 tongue and groove board. Which board and thickness is suitable depends on the roof design, support spacing and specification.
Do I need both EPDM adhesives?
The collection includes both water-based and contact adhesive because different parts of an EPDM installation can require different products. Follow the EPDM system instructions for the membrane, edges and details on your roof.


















